Precautions in the Use of Roll Forming Machine

With the continuous development of roll forming industry, cold forming technology has also developed rapidly. Cold bending machinery has become an indispensable machine for some professional factories. Then there is also a need to pay attention to the use of cold bending machinery.

To select a flat surface and stabilize the machine, the chassis feet can be pulled apart to make the machine panel easy to see. Insert the plug on the hand-held sensor head into the socket on the panel and tighten it, paying attention to the positioning gap.



Next, plug one end of the power cord into the socket on the rear panel of the chassis and the other end into the power supply socket. Be sure to use a single-phase three-wire power supply. Then open the "POWER SW." on the rear panel of the chassis and press the "SWITCHING" button on the panel. When the "WARM UP" green indicator is on, the machine will work. Press and hold the "SETTING BUTTON" button to set the appropriate value, typically between 0.5 and 2.0 seconds.

Put the sensor head on the lid again and press the start button on the handle. At this time, the "HEATING" red indicator light is on, indicating that it is heating, the sensor head is not removed, and the "HEATING" red indicator light is off. Then remove the sensor head.

After the "WARM UP" green indicator light is on or the buzzer in the machine is short "beep", the next container can be sealed. Check the sealing quality. According to different materials, diameter containers and production efficiency, properly adjust the "SETTING BUTTON" button to make the sealing quality good.www.ybtformingmachine.com

Tags:

Leave your messages:

Send Inquiry Now
Send Inquiry Now